| |
|
|
| |
double-screw mixer-A type
 
Applied range
YSH Series mixer was widely used in chemical industry, metallurgy,
food, pharmaceutical, chemical fertilizers, paints, pigments, dyes,
pesticides, rubber feed additives, refractories, fine chemicals, new
materials, electronic plastics, ceramics, mining, building materials,
and other sectors such as solid and Solid (that is, powder and powder),
liquid and liquid, powder and liquid combination. It is widely adapted
to mixed materials. Right thermo sensitive material will not produce
overheating, granular materials to be fed and ground pressure, and
size of the disparity between the proportion of different materials
produced mixed layered Segregation is not the coarse material, fine
and ultra fine grain materials, fiber or hybrid laminar have good
adaptability.
Work principle:
Mixer tube of two non-symmetric spiral rotation of the rapid lifting
of materials, forming two non-symmetric cones along the wall under
the studs-up material flow, led to the spiral arm to the campaign
to make the spiral of different materials enter stud envelope, the
materials were part of dislocation upgrade, the other part material
was thrown out stud, thus achieving a circumferential position of
constantly updated material proliferation, was mentioned in the upper
two holes materials to the convergence center, forming a downward
flow of materials, fill the bottom of the hole Yan, thus forming convection
cycle. As a result of the movement of composite, materials was mixed
with high precision in a short time.
Structure feature:
YSH-A double spiral cone mixer, which is made up of liquid spray device,
transmission, cylinder cover, spiral, cylinder, and a valve box components.
1) Liquid spray devices: device was made up of the liquid spray and
spray fluid rotary joint Components, spraying liquid components distribution
box with the bottom flange fixed stamped by the public led to a functioning
rotary joints and spray liquid components for activities connected
to a fixed rotary joint in the pipe.
2) Transmission: rotation by the motor and motor sports to the public
through Worm Gear, Gear adjusted to a reasonable speed, and then transmitted
to the spiral of the public to the two campaigns.
3) Cones covered parts: support tube covered part of the entire drive,
drive screw fixation of the tube covered, tube covered with material
for a number also observed, cleaning, and maintenance.
4) Spiral: in two non-symmetric tube with a screw for the public to
planetary movement, in the larger scope of mixture of materials, materials
to achieve rapid mixing.
5) Shell: the conical shell structure for use by materials, using
materials quickly, clean, no plot material, without discharging a
corner.
6) The valve: a valve installed in the bottom of the cylinder, used
to control supplies and materials release, the valve can be a manual,
pneumatic, electric structure of the three forms, according to user
needs to install a valve liquid (slurry valves).
Installation and appearance size
|
|
|
|
|
|
