| |
|
| |
3-D mixer
 
Usage
Many streams to the series mixer is an extensive campaign for the
pharmaceutical, chemical, food, metallurgy, light industry and research
and development units of new materials mixing equipment. It is better
applied to the mixer of flow powdered or granular materials mixed.
Feature
Catalyst series to the more active campaign by the mixer shaft universal
joints and passive support for the mixing drums in X, Y, Z axis direction
for three-dimensional movement. Apart from the cylinder rotation,
but also for the public to campaign in the cylinder for the proliferation
of materials from time to time to shear flows and campaigns to enhance
the effect of mixed materials, the three-dimensional motion of the
cylinder, to overcome the other types of mixer centrifugal force generated
mixed impact, reducing the proportion of segregation of materials
to ensure that materials the mixed results. It mainly features:
1. Mixed good and the time is short.
2. The loading coefficient, general mixer loading coefficient is not
more than 0.5, Series Multi-stream up to the campaign Mixer 0.8.
3. Small in size, simple structure and easy operation and maintenance.
4. The rotary movement of the equipment is low, and the adaptability
of the plant is good.
三、 技术参数：
Electrical control
The machines adopt three-phase 380V appliances, 50HZ AC power supply
control buttons, time relays, the machine installed on side, the electric
motor used for direct contacts and exchanges start, equipment installation,
please pay attention to grounding, in order to ensure security of
life.
Operation note:
1. Pre-boot:
Every part of the equipment should be connected fastening and reliable.
It has normal electrical wiring, no loose joints, shedding.
Give suitable modest slowdown machine lubricants, and lubricate the
chain.
Pulley equipment is flexible, easy. Cards should not have lag phenomenon.
2. Loading
According to the volume, 80% of the materials should be manual loading.
Fasten the mouth cover after you finish it.
3. Open the machine
The machine requests the equipment operator keep a dense mixed meters
away before open it, so the shell will not struck the campaign staff.
Initiate the electrical and watch whether the movement of the cylinder
is smooth.
Start button operation, mixing time after time adjustment appliances,
if need time control, time relay moved to the bottom knob continuous
state.
Table shows the number of significant speed should not above 500rpm.
People stood before the cylinder axis at the positive shift clockwise,
while you should not stand at the opposite side.
When you finish it, press the stop button to stop movement of equipment,
if the mouth is not expected below the expected location, the use
of electric button, I stopped using material in a material side to
the location, opening soon open can discharge.
Maintenance
1. Before the working of the new equipment, you should fill the new
oil, oil for 40 brands of machinery oil. One month after the operation
and then released reducer in the oil, add new oil, the future can
also check the oil every six months time.
2. Before the bearing leaves the factory, we fill enough Run-foot-hwan
fat. After one year’s operation, remove the cover of the bearing,
and add a certain amount of lubricants, lubricants for the 1st grade
sodium-calcium lubricants.
Installation, Commissioning
The whole packaging equipment for the factory, factory equipment,
the operation of all the others are spread assembly, debugging good.
Uncrating, as long as the equipment was installed in the proper position,
the use of electricity running comes into use when the bottom pad-ready.
For fixed ground, with the pin screw fixed, pre-operational, in order
to ensure security, must be properly grounded.
|
|
|
|
|
|
